Operation and cleaning of Screw air Compressor

Operation and cleaning of Screw air Compressor

  • OBJECTIVE:

To describe a procedure for the Operation and cleaning of Screw air Compressor.

  • SCOPE:

This SOP is applicable for Operation and cleaning of Screw air Compressor

  • RESPONSIBILITY:

Assistant Engineer/Above shall be responsible for implementation and compliance of  this SOP.

  • ACCOUNTABILITY:

Manager – Engineering / Manager – Production / Head – QA shall be accountable for implementation and compliance the procedure mentioned in this SOP.

  • ATTACHMENT:

Operation and cleaning of Screw air Compressor.                                  – Attachment-I

  • PROCEDURE:
    • OPERATION:
      • Before starting of air compressor, check oil level in the sight glass at the oil sump of main frame oil

level should be at 50% of sight glass.

 

  • Switch ON the main supply. The indication on the MML will shows the power is ON.
  • Switch ON the air drier.
  • Put the control switch of air compressor control panel to ON position. The HMI should display total Run hours Indication lamps show 0% load.

6.1.5   Press accept/reset push botton on the control panel. The HMI should display “machine motor status”

-Ready “load”-0%

  • Press the start button on the panel of air compressor. The HMI should display machine status-Run after 30 sec the HMI should display load.
  • CLEANING:

6.2.1   For cleaning of the Air compressor, Press OFF button and MCCB.

6.2.2   Clean air filter & Oil filter with compressed air.

6.2.3   Clean inside and outside covers of compressor with air and clean cloth.

7.0      REFERENCES:

In-house

  • ABBREVIATIONS:

SOP      : Standard Operating Procedure

Engg     : Engineering

MCCB  : Molded Case Circuit Breaker

HMI      : Human Machine Interface

  • DISTRIBUTION LIST:

Engineering

Production

Quality Assurance

 

10.0    HISTORY OF REVISION:

Version No. Effective Date Reason for Revision

 

 

 

 

 

SOPs